Side-Cutting Pliers - New England, Insulated, 245 mm
D213-9NE-INS
- Pliers are individually tested to exceed the ASTM F1505-16(2021) and IEC 60900:2018 standards for insulated electrical pliers, and are clearly marked with the official 1000-volt rating symbol
- Two layers of insulation provide protection against electric shock
- Thick, exceptionally tough, high-dielectric white inner coating is bonded to the tool
- A flame-retardant, impact-resistant, bright orange outer coating
- Made in the USA
- Precision machined knives cut cleanly and crisply, even on fine stranded wire, mule tape and pull line
- Hot-riveted joint for smooth action and no handle wobble
- High-leverage design for 46% greater cutting and gripping power than other pliers designs
- Integral guards help prevent hand contact with conductive parts
- Forged steel for maximum durability
These Klein Tools Side Cutting New England Insulated Pliers are insulated by two layers and pass both the IEC 60900 and ASTM F1505 standards. They are made of forged steel with induction-hardened knives for strength and durability. And they have a high-leverage design which provides 46-percent more cutting and gripping power than other plier designs.
Specifications
Type:
Side-Cutting Pliers
Application:
ACSR, screws, nails and most hardened wires
Special Features:
Integral guards help prevent hand contact with conductive parts.
Overall Length:
9.68'' (24.6 cm)
Overall Width:
2.49'' (6.3 cm)
Material:
Induction-Hardened Steel
Nose Type:
New England
Jaw Length:
1.91'' (4.9 cm)
Jaw Width:
1.25'' (3.2 cm)
Jaw Thickness:
0.62'' (1.6 cm)
Jaw Capacity:
1.375'' (3.5 cm)
Cutting Knives:
1
Knife Length:
0.781'' (2 cm)
Cut Style:
Side-cutting
Strips and Cuts AWG Solid:
No
Strips and Cuts AWG Stranded:
No
Screw Shearing:
No
Joint Type:
Hot-riveted
Handle Colour:
Orange
Handle Finish:
2-layer
Handle Length:
5.73'' (14.6 cm)
Insulated:
Yes
Tether capable:
No
Weight:
1.25 lb (0.6 kg)
UPC:
092644700439
Warnings
- Only use tools that are marked with the official international 1,000-volt rating symbol shown above, if there is any chance that the tools will make contact with a live electrical source.
- Whenever possible, always switch off lines and equipment prior to working on or around them. Klein insulated tools are designed only to reduce the chance of injury where the tool may make contact with a live source.
- Do NOT touch uninsulated portion of the tool or any conductive object when either might contact a live electrical source.
- Wear approved eye protection.
- Always inspect your tools before use. Destroy tool if insulation becomes damaged in any way.
- Because moisture, films or other surface contaminants are conductive, Klein insulated tools must be kept clean, dry and free from any surface contaminants.
