Grip for Large-Diameter Conductors
1628-50
- Removable jaw allows for installation of cable
- Round jaws provide maximum contact with the cable, minimising deformation
- Removable floating jaw held in place by a bolt swaged into the lever arm of the grip, secured by a nut and cotter pin
- These Made in the USA grips are special order only. Please allow 30 days for delivery. These are not returnable.
- Jaw must be removed to insert cable
- Orders must specify exact outside diameter of cables, circular mills with strand combination or manufacturer's code.
This Chicago Grip™ is specifically made for ACSR, AAC and copper cabling with larger diameters. These non-returnable grips are available by special order only. When ordering, please specify exact outside cable diameter, circular mills with strand combination or the manufacturer's code. Please allow 30 days for delivery.
Specifications
Type:
Chicago Grip
Special Features:
These grips are special order only, please allow 30 days for delivery, not returnable – Removable floating jaw is held in place by a bolt swaged into the lever arm of the grip, secured by a nut and cotter pin – Jaw must be removed to insert the cable
Cable Type:
ACSR, ACSS, ACSS-TW, AAC
Cable Diameter:
0.95'' to 1.89'' (24.13 to 48 mm)
Hot Latch:
N
Swing Latch:
N
Spring:
N
Locking Handle:
Y
Jaw Length:
10.75'' (27.3 cm)
Maximum Safe Load:
25,000 lb (11,340 kg)
Weight:
29.03 lb (13.2 kg)
UPC:
092644470660
Additional Information
Warnings
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
- When used on/near live lines, ground, insulate or isolate grip before pulling.
- Do not exceed rated capacity.
- Always match proper size and type of grip to application.
- Grips are to be used for temporary installation, not for permanent anchorage.
